Brocade Communications Systems X6-4, Руководство по установке оборудования, Страница: 153 / 249

DANGER
For safety reasons, the ESD wrist strap should contain a series 1 megaohm resistor.
CAUTION
If you do not install a module or a power supply in a slot, you must keep the slot filler panel in place. If you run the chassis
with an uncovered slot, the system will overheat.
CAUTION
Static electricity can damage the chassis and other electronic devices. To avoid damage, keep static-sensitive devices in
their static-protective packages until you are ready to install them.
CAUTION
Before plugging a cable into any port, be sure to discharge the voltage stored on the cable by touching the electrical
contacts to ground surface.
CAUTION
To avoid damaging blade and chassis, do not push the blade into a slot or pull the blade from a slot using the ejector
handles.
Blade fault indicators
Confirm that you need to replace the CP blade. The following events may indicate that a CP blade is faulty:
• The status LED on the CP blade is lit steady amber, or the power LED is not illuminated. Refer to Interpreting control processor
blade LEDs on page 106 for details on interpreting LED operation.
• The CP blade does not respond to Telnet commands, or the serial console is not available.
• The haShow command indicates an error.
• The clock is inaccurate, or the CP blade does not boot up or shut down normally.
• Any of the following messages display in the error log:
–
"Slot unknown" message relating to a CP slot
– CP blade errors or I2C timeouts
– FRU: FRU_FAULTY messages for a CP blade
– Configuration loader messages or "Sys PCI config" messages
– Generic system driver messages ("FABSYS")
– Platform system driver messages ("Platform")
– EM messages that indicate a problem with a CP blade
– Function fail messages for the CP master
Refer to Using monitoring commands on page 115 and the Brocade Fabric OS Command Reference for output examples and
additional information on Fabric OS commands.
For more information about error messages, refer to the Brocade Fabric OS Message Reference .
Blade replacement task guide
This section contains a guide to more complete, detailed steps in this section for installing or replacing CP blades when the device is
running (hot swap) or must be powered off (cold swap). References are provided to the more detailed blade removal and installation steps
for further information.
Blade replacement task guide
Brocade X6-4 Director Hardware Installation Guide
53-1004106-07 153