Brocade Communications Systems X6-4, Руководство по установке оборудования, Страница: 137 / 249

11. Pull the blade out from the slot slightly using the ejector handles until you can grasp the blade edges with your hands. Make
sure that the blade has cooled sufficiently to touch.
CAUTION
To avoid damaging blade and chassis, do not push the blade into a slot or pull the blade from a slot using the
ejector handles.
12. Continue pulling the blade from the slot by the blade edges. As you slide out the blade, place one hand under it for support. Do
not support the blade by the injector handles after removal.
FIGURE 53 Removing and replacing port or extension blade
13. If the blade is not being replaced by another blade, install a filler panel and reinstall the chassis door. The filler panel is required
for proper chassis cooling. The door is required to meet EMI compliance.
Installing a blade
Complete this procedure to install a port or extension blade. These steps apply to all port and extension blades installed in the device.
1. If a protective sleeve is covering the blade connectors remove the sleeve.
2. Rotate the ejector handles away from center of blade completely - approximately 45 degrees. Do not support the blade using
ejector handles. Orient the blade so that the handles are toward you and the flat metal side is facing down.
Installing a blade
Brocade X6-4 Director Hardware Installation Guide
53-1004106-07 137