Brocade Communications Systems X6-4, Руководство по установке оборудования, Страница: 128 / 249

Following is an example of tempShow output.
chassisX6-4:admin> tempshow
Sensor Slot Sensor State Centigrade Fahrenheit
ID Index
===================================================================
1 3 0 Ok 29 84
2 3 1 Ok 47 116
3 3 2 Ok 43 109
4 4 0 Ok 34 93
5 4 1 Ok 53 127
6 1 0 Ok 36 96
7 1 1 Ok 39 102
8 1 2 Ok 33 91
9 1 3 Ok 41 105
10 2 0 Ok 43 109
11 2 1 Ok 44 111
12 2 2 Ok 41 105
13 2 3 Ok 45 113
14 5 0 Ok 31 87
15 5 1 Ok 45 113
16 5 2 Ok 48 118
17 6 0 Ok 31 87
18 6 1 Ok 45 113
19 6 2 Ok 45 113
20 7 0 Ok 29 84
21 7 1 Ok 44 111
22 7 2 Ok 43 109
23 8 0 Ok 30 86
24 8 1 Ok 45 113
25 8 2 Ok 43 109
Note the following about this output:
• The absent state simply reflects that the blade slot is empty.
• The sensor index is mainly for support use.
• Multiple sensors are commonly averaged to determine thresholds used for managing fan speeds or for determining a high
temperature condition that may require that the blade be shut off.
Running diagnostic tests
Diagnostic tests are automatically run during POST to check the status of the device. Any error messages generated during POST are
sent to the error logs and to the serial console, if connected.
Diagnostic tests can also be run manually to test and troubleshoot the hardware and the firmware, including internal connections and
circuitry, transceivers, and port cables. However, diagnostic tests are generally intended for use by support personnel.
NOTE
Error messages do not necessarily indicate that the device requires maintenance.
Each diagnostic test can be implemented by entering the related command through a Telnet or serial session. For a list of diagnostic
tests and commands, refer to the
Brocade Fabric OS Administration Guide .
All diagnostic tests are run at all supported link speeds. They might temporarily lock the transmit and receive speeds to a specific speed.
Some diagnostic tests require interconnecting the ports to each other or using loopback plugs. If ports are interconnected, the media
(cables and transceivers) at each end of the connection must be of the same type. For example, short wavelength media must be
connected to short wavelength media, and likewise with long wavelength media and copper media.
Running diagnostic tests
Brocade X6-4 Director Hardware Installation Guide
128 53-1004106-07