Brocade Communications Systems VDX 8770-4, Руководство по установке оборудования, Страница: 23 / 141

27x40 GbE port numbering
The following illustration shows the 27x40 GbE line card modules. In the dual-port section, the top row of ports is numbered from 1
through 9 and the lower row of ports is numbered 19 through 27 from left to right when installed on the switch. The single ports on the
right of the switch are numbered 10 through 18 from left to right.
FIGURE 7 27x40 GbE line card
6x100 GbE port numbering
The following illustration shows the 6x100 GbE line card modules. Ports are numbered from 1 through 6, from left to right when installed
in the switch.
FIGURE 8 6x100 GbE line card
CFP2 to QSFP28 Conversion Module
This section provides general information about the Brocade CFP2 to QSFP28 Conversion Module.
NOTE
To install the conversion module, refer to instructions in
Replacing a CFP2 to QSFP28 conversion module on page 106.
The Brocade CFP2 to QSFP28 Conversion Module in the following illustration inserts into 100 GbE CFP2 port cages (ports) on the
6x100 GbE line card to allow connection to 100 GbE QSFP28 ports on VDX 6940-144S devices.
FIGURE 9 CFP2 to QSFP28 conversion module
To connect with VDX 6940-144S 100 GbE ports, a QSFP28 transceiver plugs into the conversion module. Use an optical QSFP to
QSFP cable with MPO connectors to connect this transceiver to the VDX 6940 ports. Refer to the following illustration.
Product Overview
Brocade VDX 8770-4 Hardware Installation Guide
53-1002563-10 23