Brocade Communications Systems VDX 8770-4, Руководство по установке оборудования, Страница: 121 / 141

3. If your transceiver as a bail release, as shown in the following figure, complete the following steps.
a) Pivot the bail on the transceiver to the horizontal position.
b) Holding the transceiver by the bail, gently pull the transceiver out of the port.
4. Insert a protective plug into the transceiver and put it aside.
FIGURE 65 QSFP cable and transceiver with bail open
1. Fiber-optic cable
2. Bail
3. Transceiver
Replacing a QSFP transceiver
Complete the following steps to replace a QSFP transceiver.
1. Position the new QSFP transceiver so that the key is oriented correctly to the port.
2. Grasping the edges of the transceiver, gently push it into the port until it is firmly seated and the latching mechanism clicks. If
your transceiver has a bail release, pull the bail up to lock the transceiver in place.
Transceivers are keyed so that they can only be inserted with the correct orientation. If a transceiver does not slide in easily,
ensure that it is correctly oriented.
3. Remove the protective plug from the transceiver.
4. Position the cable so that the key (the ridge on one side of the cable connector) is aligned with the slot in the transceiver. Insert
the cable into the transceiver until the latching mechanism clicks.
Cables are keyed so that they can be inserted in only one way. If a cable does not slide in easily, ensure that it is correctly
oriented.
Cable routing table
The following table contains a 24-port template for a cable routing table. Make copies of the table to cover the total number of ports in
the device.
TABLE 19 Cable routing table for the Brocade VDX 8770-4 (24 ports shown)
Slot/port Cable labels Connected device Slot/port of device
Slot Port Switch end Device end
1
2
Removal and Replacement Procedures
Brocade VDX 8770-4 Hardware Installation Guide
53-1002563-10 121