Brocade Communications Systems MLXe-16, Руководство по установке

Страница: 87 / 452

Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide 69
53-1002373-02
Installing 2x100GbE interface modules in Brocade MLXe routers
2
FIGURE 42 Removing the center slot guide
4. Remove the two connector covers from the rear connectors of the module. Refer to Figure 43 .
5. Remove the port cover from one or both ports, depending on how you plan to use your module.
If you are using one port only (always Port 1), you must leave the port cover in the inactive port
(always Port 2). Port covers are designed for a tight fit and will take some effort to remove.
Refer to
Figure 43 .
NOTE
Do not use the port cover tabs to lift the module. They are not designed to support the weight
of the module, which can fall and be damaged.
FIGURE 43
Port covers and connector covers
6. Insert the module into the slot until the connectors securely engage the backplane.
In 4- and 8-slot devices, the modules are installed horizontally. In 16- and 32-slot devices the
modules are installed vertically.
Figure 44 and Figure 45 show how to install 2x100G modules
in horizontal and vertical slots (4-slot and 16-slot devices are shown, but the process is the
same for 8-slot and 32-slot devices).
Plunger style Screw style
Pull up on plunger while
pulling guide out of chassis Loosen screw before
pulling guide out of chassis
Port covers
Rear connector covers
Caution: do not lift module
by port cover tabs