Brocade Communications Systems MLXe-16, Руководство по установке

Страница: 345 / 452

Brocade MLX Series and Brocade NetIron XMR Hardware Installation Guide 327
53-1002373-02
Managing the device
7
Displaying the Syslog configuration and static and dynamic buffers
To display the Syslog parameters currently in effect on a device, enter the show logging command
from any level of the CLI.
Syntax: show logging
Table 47 describes the Syslog output buffer configuration information, in the rows above the log
entries.
SNM< number > The temperature of the switch fabric module.
LP< number > The temperature of the interface module.
Temperature Monitoring Poll
Period The interval at which the system reads the temperature sensor on the
management, switch fabric, interface, and fan control modules.
MAC address
Backplane EEPROM MAC
Address The MAC address of the device.
TABLE 47 Syslog buffer configuration
Field Description
Syslog logging The state (enabled or disabled) of the Syslog buffer.
messages dropped The number of Syslog messages dropped due to user-configured filters. By default, the
software logs messages for all Syslog levels. You can disable individual Syslog levels, in
which case the software filters out messages at those levels. Each time the software
filters out a Syslog message, this counter is incremented.
flushes The number of times the Syslog buffer has been cleared by the clear logging
command. For information about clearing the Syslog buffer, refer to
“Static and
dynamic buffers” on page 328.
overruns The number of times the dynamic log buffer has filled up and been cleared to hold new
entries. For example, if the buffer is set for 100 entries, the 101st entry causes an
overrun. After that, the 201st entry causes a second overrun.
level The message levels that are enabled. Each letter represents a message type and is
identified by the key (level code) below the value. If you disable logging of a message
level, the code for that level is not listed.
messages logged The total number of messages that have been logged since the software was loaded.
level code The message levels represented by the one-letter codes.
TABLE 46 show chassis command output (Continued)
Field Description
Brocade> show logging
Syslog logging: enabled (0 messages dropped, 0 flushes, 0 overruns)
Buffer logging: level ACDMEINW, 7 messages logged
level code: A=alert C=critical D=debugging M=emergency E=error
I=informational N=notification W=warning
...