Brocade Communications Systems ICX 7250 series, Руководство по настройке

Страница: 198 / 483

Setting RIP timers
You can set basic update timers for the RIP protocol. The protocol must be enabled in order to set the timers. The timers command
specifies how often RIP update messages are sent.
To set the timers, enter the following commands.
device(config) router rip
device(config-rip-router)# timer 30 180 180 120
Syntax: [no] timers update-timer timeout-timer hold-down-timer garbage-collection-timer
The update-timer parameter sets the amount of time between RIP routing updates. The possible value ranges from 3 - 21845. The
default is 30 seconds.
The timeout-timer parameter sets the amount of time after which a route is considered unreachable. The possible value ranges from 9 -
65535. The default is 180 seconds.
The hold-down-timer parameter sets the amount of time during which information about other paths is ignored. The possible value
ranges from 0 - 65535. The default is 180 seconds.
The garbage-collection-timer sets the amount of time after which a route is removed from the rip routing table. The possible value
ranges from 0 - 65535. The default is 120 seconds.
Displaying RIP Information
To display RIP filters, enter the following command at any CLI level.
device# show ip rip
RIP Summary
Default port 520
Administrative distance is 120
Updates every 30 seconds, expire after 180
Holddown lasts 180 seconds, garbage collect after 120
Last broadcast 29, Next Update 27
Need trigger update 0, Next trigger broadcast 1
Minimum update interval 25, Max update Offset 5
Split horizon is on; poison reverse is off
Import metric 1
Prefix List, Inbound : block_223
Prefix List, Outbound : block_223
Route-map, Inbound : Not set
Route-map, Outbound : Not set
Redistribute: CONNECTED Metric : 0 Routemap : Not Set
No Neighbors are configured in RIP Neighbor Filter Table
Syntax: show ip rip
TABLE 43 CLI display of neighbor filter information
Field. Defiinition
RIP Summary area Shows the current configuration of RIP on the device.
Static metric Shows the static metric configuration. ".not defined" means the route map
has not been distributed.
OSPF metric Shows what OSPF route map has been applied.
Neighbor Filter Table area
Index The filter number. You assign this number when you configure the filter.
Displaying RIP Information
Brocade FastIron Layer 3 Routing Configuration Guide
198 53-1003903-04