Brocade Communications Systems ICX 7250 series, Руководство по настройке

Страница: 192 / 483

After globally enabling the protocol, you must enable it on individual interfaces. You can enable the protocol on physical interfaces as well
as virtual routing interfaces. To enable RIP on an interface, enter commands such as the following.
device(config)# interface ethernet 1/1/1
device(config-if-e1000-1/1/1)# ip rip v1-only
Syntax: [no] ip rip { v1-only | v1-compatible-v2 | v2-only }
Configuring route costs
By default, a Brocade device port increases the cost of a RIP route that is learned on the port. The Brocade device increases the cost by
adding one to the route metric before storing the route.
You can change the amount that an individual port adds to the metric of RIP routes learned on the port.
To increase the metric for learned routes, enter the ip rip metric-offset command.
device(config-if-e1000-1/1/1)# ip rip metric-offset 5 in
In the above example, the ip rip metric-offset command configures the port to add 5 to the cost of each route it learns.
Syntax: [no] ip rip metric-offset num { in | out }
The num variable specifies a range from 1 through 16.
NOTE
RIP considers a route with a metric of 16 to be unreachable. You can prevent the device from using a specific port for routes
learned though that port by setting its metric to 16.
The in keyword applies to routes the port learns from RIP neighbors.
The out keyword applies to routes the port advertises to its RIP neighbors.
Changing the administrative distance
By default, the Brocade device assigns the default RIP administrative distance (120) to RIP routes. When comparing routes based on
administrative distance, the Brocade device selects the route with the lower distance. You can change the administrative distance for RIP
routes.
To change the administrative distance for RIP routes, enter the distance command.
device(config-rip-router)# distance 140
In the above example, the distance command changes the administrative distance to 140 for all RIP routes.
Syntax: [no] distance number
The number variable specifies a range from 1 through 255.
Configuring redistribution
You can configure the Brocade device to redistribute routes learned through Open Shortest Path First (OSPF) or Border Gateway
Protocol version 4 (BGP4), connected into RIP, or static routes. When you redistribute a route from one of these other protocols into RIP,
the Brocade device can use RIP to advertise the route to its RIP neighbors.
Configuring RIP parameters
Brocade FastIron Layer 3 Routing Configuration Guide
192 53-1003903-04