Brobo OMRM 125 PRO, Руководство по эксплуатации

Страница: 15 / 69

14
OMRM 125 PRO
5
OCCUPATIONAL SAFETY AND MEASURES
This section contains information required for safe use of the machine and general equipment.
5.1 Safety and Accident Measures
Required warnings regarding accidents and measures to be taken are given in the Operating Manual. Still, user
is responsible for warning and guiding workplace employees for complying with the required occupational
safety rules. Workplace officers are also responsible for performing required practical follow-ups. Operator
must have full command over safety rules of the machine before starting to operate it. Current safety
components at the time of machine delivery must be kept in the same way. Manufacturing company cannot
be held legally accountable for any accident and safety gap resulting from operations that are not compliant
with use and safety requirements of the machine. The risks arising within this scope shall also affect warranty
disclaimer and again, manufacturing company cannot be held legally accountable. Any critical part requiring
replacement due to wearing etc. of the machine and other equipment must be immediately replaced. Operator
is the person who is responsible for use, cleaning, adjustment, operation, maintenance etc.
5.2 Machine Usage and Misuse
OMRM 125 PRO machine is designed to cut aluminum and PVC profiles. The user is responsible for any
machine faults and occupational safety gaps to be resulted from procedures other than this.
5.3 General Safety Rules
Only one operator must work on OMRM 125 PRO machine. Operator must not operate the machine in case of
any lack of attention caused by drugs, alcohol or medication. Operator must check the machine and components
prior to operation. Main switch, electricity and pneumatic must absolutely be switched off during the routine
maintenance. Any pressure must be discharged in case any hydro-pneumatic equipment is present. Do not
replace the equipment and safety parts on the machine. Do not lift the safety device and barriers. Operator
must wear a uniform suitable for machine and manufacturing requirements. Operator must not wear any
rings, bracelets etc. which may cause an accident. Staff with long hair must use hair nets, if necessary. The
machine must be installed in accordance with the training provided by M.S.K. company experts.
5.4 Maintenance Measures for Safety
All maintenance procedures must be performed by expert technicians who have command over the periodical
technique. Use predefined proper equipment for machine maintenance.
5.5 Electrical Safety Rules
Severe occupational accidents and injuries may occur in case of failure to comply with the safety rules described
in this manual. Electrical intervention and maintenance must only be performed by authorized personnel. All
procedures must be performed using proper and isolated equipment. Take notice of safety signs and do not
remove them. Do not make any addition and subtraction on the voltage line. Use original spare parts and
equipment. No changes in circuits are allowed. Shut down the electrical equipment before every cleaning
procedure. Main cabinet and cabinet doors must be closed. In case of fire, turn off the main switch and use
proper fire extinguisher equipment.
CAUTION : Hardware panel locks must remain in the possession of authorized staff.
5.6 Lighting
Work with proper lighting values for operator safety and health. The minimum illumination value for the use
of machine is set to be 300 lux. For more technical information, please see EN 12464-1 Lighting Standard.
5.7 Connections
All necessary connections must be prepared at the placement area in line with the machine. Requirements
such as electrical power, pneumatics etc. must be at values meeting requirements, and compatible equipment
must be kept available at the placement area. Take IEC 64-8 standard into consideration for the installation of
electrical equipment.
CAUTION : If there is a power-supply in the system, it must have a 0.3A circuit breaker property.
Commissioning procedures must be performed by specialized staff.