Broadxent Di3631, Руководство пользователя, Страница: 54 / 60

Troubleshooting B-4
Resolving Hardware
Conflicts
Hardware conflicts may occur when two or more peripheral devices are set to use
the same I/O address, IRQ line or DMA channel.
To resolve conflicts in Windows 95, Windows 98/98SE, Windows 2000, Windows Me
or Windows XP, change the resource settings of your modem or the conflicting
peripheral device using Device Manager.
Resolving Conflicts
in Windows 95/98/
98SE/ME
To run Device Manager:
1. Click Start -> Settings -> Control Panel .
2. Click the System icon. The System Properties dialog box appears.
3. Click the Device Manager tab.
4. Double-click Modem .
5. Select your modem and click the Properties button. The Properties dialog box
of the modem appears.
6. Click the Resources tab.
7. Click the Use Automatic Settings check box to select it. If this check box is
already selected, you need to go to the Properties dialog box of the conflicting
peripheral device and select the same check box there.
8. Restart your system to allow Windows 95/98/98SE to reassign resources to your
modem and/or the conflicting peripheral device.
If you are unsure of which
peripheral device is causing
the conflict, you can isolate
the source of the problem by
temporarily removing all
devices (except your modem
and essential devices such as
the disk controller). After
that, add the devices back
one at a time until the device
that is causing the conflict is
found.