Broadcom Emulex LPe12000 Series, Руководство по установке

Страница: 21 / 50

Broadcom LPeHBAs-IG126-100
21
Emulex Host Bus Adapters Installation Guide
LPe12000 HBAs have one six-post jumper block that controls the HBA’s device ID.
LPe12002 HBAs and LPe12002-X8 HBAs have two six-post jumper blocks that control the HBA’s device ID for ports 0 and 1.
LPe12004 HBAs have four six-post jumper blocks that control the HBA's device ID for ports 0, 1, 2, and 3.
Select the ID by installing a jumper between posts 1 and 2, or 3 and 4, or 5 and 6, as described in Table 15 .
NOTE: Without a jumper, the HBA reports a device ID of 0x1AE5. Most software drivers require a PCI device ID of F100
to properly identify and control the HBA. Do not attempt to operate the HBA with the PCI device ID set to 0x1AE5
unless recommended by the driver installation instructions.
Figure 8: Jumper Settings
2.6 Special Features of LPe32000-Series and LPe31000-Series HBAs
LPe32000-series HBAs and LPe31000-series HBAs have the following two unique hardware features:

You can change the speed of the HBA.

You can enable or disable the Secure Firmware feature.
This section explains how to use these features.
2.6.1 Changing the Speed of the HBA
On some HBAs, you can change the speed of the link from 16GFC to 32GFC, or from 32GFC to 16GFC, by replacing the
optical transceivers. The transmission speed of the LPe31000-series and LPe32000-series HBAs can be changed in this
way.
Table 15: Jumper Settings
PCI Identifier P0_JX (Port 0) P1_JX (Port 1) P2_JX (Port 2) P3_JX (Port 3)
F100 1–2 1–2 1–2 1–2
F101 3–4 3–4 3–4 3–4
1AE5 5–6 5–6 5–6 5–6