Broadcom Brocade X6-4, Руководство по установке

Страница: 128 / 208

53-1004106-15 Installation Guide Brocade
®
X6-4 Director Hardware Installation Guide
Removing a Blade
Complete the following steps to remove a CP blade.
NOTE
The chassis continues to operate while a CP blade is being replaced if the redundant CP blade is active and a
failover does not occur. You can prevent failover by entering the haDisable command.
1. Remove the chassis door.
2. Log on to the active CP as the admin user. You can use a serial cable or telnet, Web Tools, or Fabric Manager.
Determine which CP is active using the haShow command or view the active LED on the front of the CP.
3. Perform one of the following steps to ensure that the faulty blade is the standby blade.
•
If the faulty blade is the standby CP blade, skip to Step 4.
•
If the faulty blade is the active CP blade, issue the haFailover command. Wait until the failover has completed.
Use the haShow command to verify the CPs are synchronized and the failover is complete.
Depending on the nature of the failure, it is possible that the haFailover command may not work. Proceed to the
next step anyway.
4. Enter the haDisable command. This is required before physically removing and replacing a CP blade.
5. Disconnect all cables from the faulty (standby) CP blade.
6. Loosen the captive screws for both ejector handles on the blade using a No. 1 Phillips screwdriver.
Loosening the screws initiates a hot-swap request and disconnects power from the blade. The spring-loaded captive
screws will pop out from the slot .63 cm (.25 in.) when fully disengaged. Do not eject the blade using blade handles
until screws disengage from the slot and the power LED is off.
7. Grasp both ejector handles and simultaneously pull them away from the center of the blade using equal pressure to
approximately 45 degrees (fully open).
As you move the handles, you will hear connectors disengaging from the backplane connector and possibly a slight
popping noise. This is normal and is due to the dense backplane. The blade will move out approximately 1.27 cm (.5
in.) from the slot when fully disengaged.
8. Pull the blade out from the slot slightly using the ejector handles until you can grasp the blade edges with your hands.
Make sure that the blade has cooled sufficiently to touch.
CAUTION
To avoid damaging blade and chassis, do not push the blade into a slot or pull the blade from a slot using the
ejector handles.
53-1004106-15
128