Broadcom Brocade G630, Руководство по установке оборудования

Страница: 59 / 106

NOTE
You should not use tie wraps with optical cables because they are easily overtightened and can damage the optic
fibers.
CAUTION
Before plugging a cable into any port, be sure to discharge the voltage stored on the cable by touching the electrical
contacts to ground surface.
• Plan for rack space required for cable management before installing the switch.
• Leave at least 1 m (3.28 ft) of slack for each port cable. This provides room to remove and replace the switch, allows for
inadvertent movement of the rack, and helps prevent the cables from being bent to less than the minimum bend radius.
• If you are using Brocade ISL Trunking, consider grouping cables by trunking groups. The cables used in trunking groups must
meet specific requirements, as described in the
Fabric OS Administrator’s Guide .
• For easier maintenance, label the fiber-optic cables and record the devices to which they are connected.
• Keep LEDs visible by routing port cables and other cables away from the LEDs.
• Use hook and loop style straps to secure and organize fiber-optic cables.
Installing an SFP+ transceiver
The device supports only Brocade-qualified transceivers. If you use an unqualified transceiver, the switchshow command output shows
the port in a Mod_Inv state. Fabric OS also logs the issue in the system error log. To insert an SFP+ transceiver, complete the following
steps:
Installing an SFP+ transceiver
Brocade G630 Hardware Installation Guide
53-1005235-02 59