Broadcom Brocade G630-1, Руководство по установке оборудования

Страница: 50 / 99

53-1005235-09 Installation Guide Brocade
®
G630 Switch Hardware Installation Guide
2. Disable any serial communication programs running on the workstation, such as synchronization programs.
3. Open a terminal emulator application, such as PuTTY, XShell, or SecureCRT on a Windows PC, or TERM, TIP, or C-
Kermit in a Linux environment, and configure the application as follows:
•
In a Windows environment, use the following values.
Parameter Value
Bits per second 9600
Data bits 8
Parity None
Stop bits 1
Flow control None (must be disabled on the host side)
NOTE
Flow control is not supported on the serial connection when attached to a remote terminal and must be
disabled on the customer-side remote terminal server in addition to the host-side clients.
•
In a UNIX environment using TIP, enter the following string at the prompt:
tip /dev/ttyb -9600
If ttyb is already in use, use ttya instead and enter the following string at the prompt.
tip /dev/ttya -9600
4. When the terminal emulator application stops reporting information, press Enter to display the login prompt.
Switch Console Login:
5. Log on to the device as admin, using the default password ( password ). You are prompted to change the default user
name and password at initial logon. Make sure to write down the new credentials and keep this information in a secure
location.
Fabric OS (swDir)
swDir login: admin
Password:
Please change your passwords now.
Use Control-C to exit or press 'Enter' key to proceed.
swDir:admin>
6. Modify the credentials. To cancel, press Ctrl+C .
NOTE
Initial passwords can be 8 to 40 characters long. They must begin with an alphabetic character. They can
include numeric characters, the period (.), and the underscore (_) only. Passwords are case-sensitive, and
they are not displayed when you enter them on the command line.
Configuring the IP Address
You can configure the device with a static IP address, or you can use a Dynamic Host Configuration Protocol (DHCP)
server to set the IP address of the switch. DHCP is enabled by default. The device supports both IPv4 and IPv6
addresses.
Using DHCP to Set the IP Address
When using DHCP, the switch obtains its IP address, subnet mask, and default gateway address from the DHCP server.
The DHCP client can connect only to a DHCP server that is on the same subnet as the switch. If your DHCP server is not
on the same subnet as the switch, use a static IP address.
53-1005235-09
50