Broadcom BCM5706C, Руководство пользователя

Страница: 246 / 247

NetXtreme II User Guide
January 2010
Bro a d c o m C o rp o r a ti o n
Page 246 Linux Document ENGSRVT52-CDUM100-R
L
INUX
Problem : On kernels older than 2.6.16 when 16 partitions are created on a server containing two BCM57711 network
adapters, not all partitions would come up and an error indicating a shortage of space would display.
Solution : On architectures where the default vmalloc size is relatively small and not sufficient to load many interfaces, use
vmalloc=<size>
during boot to increase the size.
Problem : Routing does not work for NetXtreme II 10 GbE network adapters installed in Linux systems.
Solution : For NetXtreme II 10 GbE network adapters installed in systems with Linux kernels older than 2.6.26, disable TPA
with either ethtool (if available) or with the driver parameter (see disable_tpa ). Use ethtool to disable TPA (LRO) for a specific
NetXtreme II 10 GbE network adapter.
Problem : On a NetXtreme II 1 GbE network adapter in a CNIC environment, flow control does not work.
Solution : Flow control is working, but in a CNIC environment, it has the appearance that it is not. The network adapter is
capable of sending pause frames when the on-chip buffers are depleted, but the adapter also prevents the head-of-line
blocking of other receive queues. Since the head-of-line blocking causes the on-chip firmware to discard packets inside the
on-chip receive buffers, in the case a particular host queue is depleted, the on-chip receive buffers will rarely be depleted,
therefore, it may appear that flow control is not functioning.
M
ISCELLANEOUS
Problem : When setting the Jumbo MTU property to 5000 bytes or greater and forcing Flow Control on network adapters
that support a link speed of 10 Gbps, the system performance performs at less than optimal levels.
Solution : If Jumbo MTU is set to 5000 bytes or greater, ensure that Flow Control is set to Auto .
Problem : iSCSI Crash Dump is not working.
Solution : After upgrading the device drivers using the installer, the iSCSI crash dump driver is also upgraded, and iSCSI
Crash Dump must be re-enabled from the Advanced section of the BACS Configuration tab.
Problem : In Windows 2008 R2, if the OS is running as an iSCSI boot OS, the VolMgr error, “The system could not
successfully load the crash dump driver,” appears in the event log.
Solution : Enable iSCSI Crash Dump from the Advanced section of the BACS Configuration tab.
Problem : Although installed, the Broadcom Advanced Control Suite 3 (BACS) application does not start and an error
message appears.
Solution : .NET Framework 2.0 is required for BACS 3 to operate. Install .NET Framework 2.0.
Problem : Broadcom Advanced Control Suite 3 takes a long time to start up.
Solution : This is a limitation of .NET Framework 2.0. Apply .NET Framework 2.0 SP1 and reboot your system.