Brixton BX125, Руководство по обслуживанию

Страница: 64 / 148

63
If the main wiring end is checked as completely normal, check whether the voltage and current
regulator plug is in proper contact, and measure the impedance values between the terminals of the
voltage and current regulator.
* Attentions
•
Do not touch the metal part of
multimeter probe with your finger.
•
Check with a multimeter. If impedance
values measured by different multimeters
are not the same, it indicates incorrect
inspection.
When impedance value between terminals is abnormal, voltage regulator shall be replaced.
Multimeter
Positive
Negative
Yellow
1
Yellow
2
Yellow
3
Black Red
Unit: MΩ
Yellow 1 0.1~3 0.1~3 None None
Yellow 2 0.1~3 0.1~3 None None
Yellow 3 0.1~3 0.1~3 None None
Black None None None None
Red None None None None
5.6 Generator Charging and Lighting Coils
* Attentions
Inspection of generator charging coil can
be performed on the engine.
Inspection
Disconnect the 4P connector on the generator.
Use a multimeter to measure impedance value between white coils of the generator and vehicle
block.
Standard value: 0.6-
1Ω(20
℃
)
测定值超过标准值时发电机线圈更换。
If measured value exceeds the standard value, the generator coiling shall be replaced.
KS MOTORCYCLES - http://ksmotorcycles.com