Defender Cruise
Control
Vr. 1.
Britpart, The Grove, Craven Arms, Shropshire, SY7 8DA United Kingdom
www.britpart.com
Fitting & Operation Instructions
Part Number - DA7480
Disclaimer
These fitting instructions are intended for general guidance only. No responsibility will be accepted for damage to persons, property, equipment or vehicles
caused during or arising from the fitment or using of this product. Fitting this item to your vehicle may constitute a vehicle modification and therefore we
strongly recommend that you check the product complies with local laws and legislation and always inform the vehicle's insurance company accordingly.
Before Installation
These installation instructions contain information on how
to install the E-Cruise, which is not a Do-It-Yourself job.
Modern cars are equipped with electronics which can be
damaged by inappropriate treatment. Britpart cannot be
held responsible for any error caused by an incorrect
installation.
Check that all the parts are included in the kit.
1 x Unit
1 x 14-p connector
1 x 12-p connector
5 x Cable ties
1 x Installation & Operation guide
Recommendations
>
Always disconnect the negative cable from the battery
before installing.
>
Always use the enclosed installation instructions for
installing the E-Cruise.
>
The rev. number on the unit label and the installation
guide must be the same.
>
Be aware that, for example, the radio code might have
to be typed in.
>
Find a location to install the unit and control switch.
>
If any wire(s) are left, then cut them off and insulate.
>
Only use a multimeter to measure.
>
Flying lead(s) must be soldered.
>
All wire connections are viewed from wire side.
Operating Instructions
E-Cruise will gently regulate the selected speed within the range of options offered by the vehicle.
Please read these instructions carefully.
On/Off
Activate
ON/OFF
to turn E-Cruise on and off. E-Cruise automatically turns off when the engine is
switched off.
Set
Drive at a constant speed and briefly activate
SET/COAST
. Remove your foot from the accelerator
pedal as E-Cruise take control of the accelerator function of the vehicle.
Turn Off
To deactivate the E-Cruise, press the brake or clutch pedal. The E-Cruise will remember the last
selected speed.
Resume
Active
RES/ACC
and the vehicle will return to the speed last selected unless the ignition has been
switch off or
ON/OFF
has been activated in the meantime.
Decelerate
Activate and hold
SET/COAST
for more than one second and the E-Cruise will gradually decrease
speed until
SET/COAST
is released. The speed when
SET/COAST
is released will then be the new
speed selected. A quick tap on the
SET/COAST
will decrease speed by approximately 0.6mph
per touch.
Accelerate
Activate and hold
RES/ACC
for more than one second and the E-Cruise will gradually increase speed
until
RES/ACC
is released. The speed when the
RES/ACC
is released will then be the new speed
selected. A quick tap on
RES/ACC
will increase speed by approximately 0.6mph per touch.
WARNING
It is not recommended to use E-Cruise at speeds below 30mph, in congested areas, at excessive speeds or in adverse
weather conditions.
