BRITISH RECYCLED PLASTIC
Unit 8C, Top Land Country Business Park, Cragg Road, Mytholmroyd, HX7 5RW
Tel: 01422 885761
Email: [email protected]
britishrecycledplastic.co.uk
Adult Picnic Table Assembly Instructions
PLEASE READ THESE INSTRUCTIONS CAREFULLY AND FOLLOW THE ASSEMBLY DRAWINGS.
WE WILL NOT ACCEPT ANY CLAIMS IF THIS PRODUCT IS WRONGLY ASSEMBLED.
Parts Supplied
Tools Required
a) 2 × A-Frame supports
b) 10 × Seat & table slats [labelled 1 to 10]
c) 2 × Angle braces
d) 2 × Seat ties
e) 3 × Table tie
f) 2 × Outer table ties
g) 2 × Metal table brackets
h) 44 × 90mm screws
i) 16 × 70mm screws
j) 18 × 50mm screws
Power drill with Philips screwdriver bit
Measuring tape
Straight edge
2 Person Operation
2.
3.
1.
2 × Seat slats [2&9]
8 × 90mm screws
2 × A-Frames
2 × Seat slats [1&10]
8 × 90mm screws
2 × Table slats [3&8]
8 × 90mm screws
• Position seat slats [2&9] with a 25mm
gap between slats.
• Square the ends with a straight edge.
• Fix with 90mm screws.
• Position outer table slats 3 and 8 with a 10mm overhang
and 245mm from horizontal support to end of slat.
• Loosely secure outer holes with 90mm screws.
• Ensure slats are square by measuring the
diagonals. The diagonals should measure the same.
• Tighten the outer screws once the table is square.
• Fix inner holes with 90mm screws.
• Stand end A-Frames upright on a flat surface with horizontal
support facings on the inside.
• Position seat slats 1 and 10 as the diagram, and locate pilot
holes in the A-Frames through the predrilled outer holes of the
slats, secure loosely using 90mm screws - but do not fully
tighten. (This will give a 10mm overhang and 245mm from
horizontal support to end of slat).
• Ensure that the frames are square by measuring across
the diagonals. The diagonals should measure the same.
• Tighten the outer screws once the table is square.
• Fix the inner holes with 90mm screws.
