05
08
5. SEAT UNIT FITTING AND REMOVAL
WARNING: Always remove your child from the stroller
seat before installing or changing direction of the seat.
A.
Take the seat unit face up. Hold it facing forwards
or backwards. Line up plastic moulding on sides
of seat unit with sockets in the middle of stroller
frame, and then push in all the way until locked.
Ensure the seat is locked on by trying to pull out.
B.
To remove the seat use your thumbs, press down
and hold both seat unit release buttons located
beside ends of armrest bar. While holding in
buttons grasp the seat frame with your fingers and
lift it off the stroller.
6. ARMREST BAR FITTING AND REMOVAL
A.
Take armrest bar, line up locking post ends with
holes on the middle of the seat frame, then push
armrest bar on.
C.
To remove push in and hold small button at end of
the bar to unlock then pull from socket, repeat on
other side to fully release.
Note: Do not lift stroller by armrest bar because it may
disengage.
13. STROLER FRAME CLOSING AND FOLDING
Note: Seat unit can be removed to reduce the total folded
size if required. Adjusting the leg support will shorten stroller
total length when folded if needed. Refer to section 10 for
instructions.
A.
Engage rear brakes. Remove all objects from seat back
pocket and basket and close the canopy before folding.
With seat unit attached:
i.
If seat unit in child facing away from parent mode, then
adjust the backrest to most upright position (1)
ii.
If seat unit in child facing parent mode, then adjust the
backrest to most reclined position (3)
B.
With right hand squeeze centre lever and slide handle
into frame. At the same time continue to squeeze the
centre lever and push the button on left side of the
handle.
Continue to slide handle into the frame until it goes no
further and the frame is released. Push downward as
frame releases to fold.
C.
If frame does not release in the folding direction then
repeat step D again.
14. RAIN COVER
A.
The rain cover may be used with stroller or
bassinet.
B.
Open the canopy and unfold rain cover. Fit
top end of cover with 3 smaller wedge
sections over the canopy. Fit elastic section
of front edge of cover over front of leg
support or end of bassinet base.
C.
To remove reverse fitting procedure.
www.britax.com.au
www.britax.com.au
A
A
Ai
Aii
B
A
A
