04
09
A.
Release frame lock.
B.
Grasp handle and lift upward to expand frame until
left and right sides click into position
Note: Ensure that both sides of the frame are locked
by pushing downward on the handle.
2. REAR WHEEL FITTING AND REMOVAL
A.
Push each rear wheel into the frame until they lock
into position. Ensure both rear wheels are locked
by trying to pull them off.
B.
To release press and hold the release lever before
pulling the wheel assembly off.
3. FRONT WHEEL FITTING AND REMOVAL
A.
Take front wheel assembly push into shaft until it
locks. Ensure both front wheel sets are locked by
trying to pull them off.
B.
To remove the wheel assembly turn top “unlock”
knob to the left and pull off the frame.
4. SWIVEL LOCKS
A.
To lock the front swivel wheels, press down both levers
to locked position. The swivel will lock automatically
when wheels turn to straight forward position.
B.
To unlock raise both levers up.
ASSEMBLY/USE
15. BASSINET ASSEMBLY, FITTING & REMOVAL
WARNING: Always remove your child from the bassinet
before fitting or removing from stroller.
A.
To assemble bassinet, extend the bassinet frame
support rods by slowly sliding centre of each bar
outward until they lock under all 4 clips. Push down
lightly on the top edges of the bassinet to check that
they are locked in place.
B.
Fit liner and pad into bassinet.
C.
Open canopy by pressing and holding each button on
outside of canopy pivot joint before tilting carry handle
bar to vertical position
D.
To fit bassinet to stroller refer to seat installation in
section 5.
E.
To remove bassinet from stroller unlock by pushing
down and holding the second lock spring at centre of
bottom edge of canopy. Continue to hold the spring
down before firmly lifting up and unlocking main lever.
F.
Once released lift the bassinet straight up off the
stroller.
Note: The frame will not fold with bassinet installed.
Note: D-rings are installed in the base of the bassinet
for optional baby harness installation. Baby harness is
not supplied but can be purchased separately. Refer to
instruction included with baby harness for correct fitting.
Note: A body band is also installed in the base of the
bassinet for optional use. To use the body band, remove
the mattress, open the body band, and then place the
mattress back into the bassinet. When not in use store
body band under the mattress.
1. STROLLER FRAME OPENING
www.britax.com.au
www.britax.com.au
A
B
A
A
A
C
B
B
E
