Instructions for Installation & Use
31
CHILD USE
(BOOSTER SE
AT
MODE WITH CHILD HARNE
SS
)
HOW TO INSTALL CHILD HARNESS
HOW TO INSTALL CHILD HARNESS
CONVERTING A LAP-SASH
SEATBELT FOR USE WITH THE
CHILD HARNESS.
With the booster the seat installed in the vehicle,
sit the child in the seat. Fit the vehicle lap sash belt
into the vehicle buckle and position the lap strap
over the child's hips and thighs. Ensure all slack is
removed from the lap strap.
Locate the gated slide for the next step.
Take the sash strap away from the child's chest
and place together with the lap strap across the
hips and thighs. Engage the straps into the gated
slide with the hollow side towards the booster seat.
Check and ensure that no lap belt slack is caused
while fitting the gated slide.
The gated slide should be close to the child but not
touching and should guide the sash belt back to
the retractor away from the child.
For further details on fitting the gated slide, see
page 32 to 33.
Check and adjust the crotch buckle height to suit
the child. With the SecureGuard™ Device hooked
over the lap belt, the lap belt should sit within the
red clip and should not be able to lift up into the
abdomen region of the child.
Both the converted lap/sash seatbelt and
SecureGuard™ Device are now setup. Proceed
to page 34 to fit the child harness to the child in
readiness of vehicle travel.
Gated Slide
:
Do not use a child harness with just a vehicle seatbelt. Only use with a compatible booster seat
and lap belt, or converted lap-sash seatbelt.
DO NOT LEAVE CHILDREN UNATTENDED IN THE CAR.
