Britax Frontier XT SICT, Руководство пользователя

Страница: 17 / 56

30 31
1
Rotate the recline block to the
front and place the child seat
on the vehicle seat.
* Ensure harness height is
adjusted to fit your child.
2
Pull the vehicle seat belt out and
route the belt through the first
belt slot, under the cover and
through the second belt slot.
3
Verify that the belt is not
twisted, then buckle.
4
Push the child seat firmly
into the vehicle seat while
removing all slack from the
vehicle seat belt.
* Ensure that the vehicle seat
belt is locked as directed by
your vehicle owner’s manual.
* The child seat is secure when it
cannot be moved front-to-back
or side-to-side more than 2.5
cm (1 in.) at the belt path. If the
child seat is not secure, repeat
the installation procedure or
use a different seating location.
5
Firmly press the Versa-Tether
hook to the vehicle tether
anchor to attach. Remove all
slack from the tether webbing.
6
Use the elastic strap to contain
extra webbing.
2
3
OR
OR
Checklist
9
Check that positioning block is rotated to the front.
9
Check all connections and verify that child seat is secure.
* The child seat is secure when it cannot be moved front-to-
back or side-to-side more than 2.5 cm (1 in.) at the belt path.
If the child seat is not secure, repeat the installation procedure
or use a different seating location.
9
Ensure any excess Versa-Tether
®
webbing is stored in elastic
band. Always ensure any excess webbing is contained within
your vehicle.
This seat may only be used in booster mode with children who
stand 106.7 – 165.1 cm (42 – 65 in.) in height and weigh more than
18.1 kg (40 lbs). Britax recommends booster mode only after the
child outgrows harness mode.
Harness.to.Booster.Mode
To.remove.the.harness.and.buckle:
1
Loosen the harness.
a Press release lever
b Pull both harness straps forward
2
Remove the belt shield and
unhook the harness straps from
the yoke.
3
Replace the belt shield (a) then
store the yoke in the slot (b).
4
Pull the harness straps out of
the slots.
* DO NOT remove the HUGS™
chest pads or chest clip.
5
On the bottom of the seat,
slide the retainer of one
harness strap up and pull it
away from the child seat shell.
Installing the Child Seat: Harness Mode Switching Between Modes