BRISTELL S-LSA, Руководство по техническому обслуживанию и инспекции

Страница: 124 / 201

10.CHAPTER
– POWER UNIT
Document: SLSA-MIP-5-4-0-US Date of Issue: 05/2016 Revision: -
10-18
Unscrew nuts (8), remove bolts (7) and take out the propeller along with other parts
from the flange.
Put the protective covers on the propeller blades and store the propeller on a safe place
so that no damage can occur.
Fig. 10-15
Removal / Installation of propeller
1 - Propeller spinner 2 - Propeller hub
3 - Spacer 4 - Propeller flange on the
engine
5 - Propeller spinner flange 6 - Washer
7 - Bolt 8 - Nut
10.3.4 Installation of the propeller
Type of maintenance: line
Authorization to perform:

Sport pilot or LSA mechanic
NOTE
For the Fiti 3LRSE propeller installation refer to the OPERATING INSTRUCTIONS AND
TECHNICAL DESCRIPTION OF FITI ECO COMPETITION, IN-FLIGHT ADJUSTABLE
PROPELLER
Check the contacting areas of the flange of the reducer propeller shaft and the propeller.
Clear off all impurities.
Remove protective covers from the propeller blades and carry out visual check of the
propeller integrity.
Attach the propeller hub (2) and spinner flange (5) to the propeller flange on the engine
(4) by bolts (7), washers (6) and nuts (8).
Tighten bolts (7) gradually according to the Fig. 10-16. Refer to the propeller manual for
the torque moments.