Important Safety Information
Important Safety Information
Important Safety Information
Important Safety Information
• Please read these instructions thoroughly and retain for future use.
• All products manufactured and supplied by Bristan are safe provided they are installed
correctly, used correctly and receive regular maintenance in accordance with these
instructions.
• If you are in any doubt about your ability to install this product safely you must employ the
If you are in any doubt about your ability to install this product safely you must employ the
If you are in any doubt about your ability to install this product safely you must employ the
If you are in any doubt about your ability to install this product safely you must employ the
services of an experienced qualified plumber.
services of an experienced qualified plumber.
services of an experienced qualified plumber.
services of an experienced qualified plumber.
• Remove all packaging and check the components for damage before starting installation.
•
Before starting any installation please consider the following: Prior to drilling into walls,
check that there are no hidden electrical wires, cables or water supply pipes. This can be
checked with the aid of an electronic detector.
• If power tools are used do not forget to:
- Wear eye protection
- Unplug equipment after use
• This product must
must
must
must not be modified in any way as this will invalidate the guarantee.
• These fittings need to be installed in accordance with and meet the requirements of the Water
• These fittings need to be installed in accordance with and meet the requirements of the Water
Supply (Water Fittings) Regulations 1999 and Scottish Byelaws 2004.
General Specifications
General Specifications
General Specifications
General Specifications
Operating pressure range (bar)
Min
Max
Basin Taps
0.2
8.0
Bath Taps
0.2
8.0
Bath Filler
0.2
8.0
Bath Shower Mixer
0.2
8.0
Maximum static pressure – 10.0 bar
NOTE:- Nominally equal (balanced) inlet supply pressures are recommended for optimum
Performance of mixer taps.
Designed to comply with BS EN 200 for single taps / combination taps for water systems of type 1
and 2 general technical specifications; and to be used within systems designed to BS 6700.
BS 6700 recommends the temperature of stored water should never exceed 65°C. A stored water
temperature of 60°C is considered sufficient to meet all nominal requirements and will minimise
the build up of lime scale in hard water areas.
03