BriskHeat
®
Corporation. All rights reserved
5
Hot Gun for Composite Curing
4. Attach power cord from hot gun to TTQSD S16 temperature controller.
5. Using the provided roll of AAT260 aluminum adhesive tape, attach the sec-
ond thermocouple to the front bond line of the click-stud closest to the gun
(Figure 3) For best results, ensure that the tip of the thermocouple is on the
bond line but not touching the adhesive and the entire assembly is covered with
aluminum tape. Plug the process control thermocouple attached to the pin to
the controlling thermocouple input on the back of the TTQSD S16temperature
controller (Figure 4).
Firugre 4
6. Place the output hot gun nozzle 2” (50mm) from the bond line.
Position the hot at a 20° angle pointing downward at the bond line.
Firugre 3
