BriskHeat
®
Corporation. All rights reserved
3
Hot Gun for Composite Curing
A person who has not read
and understood all operating
instructions is not qualified to
operate this product.
Do not immerse heater in liquid.
Keep volatile or combustible material away from
heater when in use.
Use heater only in approved locations
Keep sharp metal objects away from heater.
Failure to observe these warnings may result in
electric shock, risk of fire, and personal injury.
Only qualified personnel are allowed to connect
the electrical wiring.
Disconnect all supply power at the source before
making any heating cable power input connec-
tions.
All electrical wiring must follow local electrical
codes and highly recommend following NEC
Article 427.
Final installation / wiring is to be inspected by
the authority who has jurisdiction in the area that
the heater is installed.
The end-user is responsible for providing a
suitable disconnecting device.
The end-user is responsible for providing suita-
ble electrical protection device. It is highly rec-
ommended that a ground fault circuit breaker be
used.
IMPORTANT SAFETY INSTRUCTIONS
Never handle the heater while it is
in operation; always disconnect the
heater from the power source and
allow to cool prior to handling.
Inspect heater and connection kits
before use.
Never operate heater without a
temperature control device.
Do not wrap the heating cable over
itself
If spillage of foreign matter onto
heater occurs, disconnect from
power source and clean after heat-
er is allowed to cool
Never operate a heater without an
appropriate heat sink (device being
heated is considered a heat sink)
Do not operate heater above rated
temperature value
Fasten heater to device using
approved methods only
Do not repair damaged or faulty
heaters.
Do not crush or apply severe physi-
cal stress on heater or cord assem-
bly.
Disconnect heater when not in use.
Failure to observe these warnings may
result in personal injury or damage to the
heater.
