BitPipe™Cellular Dev
-Kit
User Guide
Copyright 2017 Briowireless Inc.
12
Figure 8 USB serial port listed for the FTDI communication cable
7.1.3
Dev-kit connections
To use the dev-kit in modem UART mode:
-
Connect the communication cable (TTL-232R-3V3-2MM) in the FTDI Connector (box 5 in
Figure 2).
-
Configure the dipswitches in modem UART mode (SW1-1 = OFF, SW1-2 = OFF, SW1-3 = OFF).
See section 5.4 for details.
-
Connect the Wall adaptor in a power outlet. Insert the barrel plug in the demo board power
connector (box 7 in Figure 2). The modem will boot automatically and the
“Power ON”
LED
(D1 next to the power connector) will turn ON when the modem is ready to establish a
communication with the PC.
-
