Briot emotion, Руководство по эксплуатации

Страница: 91 / 210

Using your Edger... Operating ranges:
3-90
3.6.3 D
RILLING
3.6.3.1 C
ONDITIONS
>
Only CR39, polycarbonate, high index (HI) and Trivex™ materials can be drilled.
> A mineral lens cannot be drilled.
3.6.3.2 L
IMITS OF HOLE POSITIONING
> Whatever the type of hole, it must be drilled in a specific zone which is defined following the diagrams below.
>
The following constraints must be observed:
→ The circle radius beyond which drilling is possible:
Note: When it is impossible to drill a hole (hole positioned in the end-pieces, notch passing
through the centre of the shape, this hole is shown in black in the screen. Some
holes displayed in blue in the screen may be impossible to drill after they have
been felt (holes too deep, unadapted angle, unadapted end-piece, etc.). In these
cases, these holes will be displayed in gray in the screen and only marked with
the mill bit end (with maximum inclination angle) during the drilling phase, once
the operator has accepted the marking.
→
The ring formed by the edge of the lens and the internal perimeter of the lens beyond which
drilling is not permitted:
A
LL HOLES
,
WHATEVER THE TYPE
,
MUST BE WITHIN A
12 mm
RING
.
Note: If a job includes a hole placed at a distance of more than 12 mm from the edge of the
shape, the following message is displayed: « Hole deleted. At least one of the
holes cannot be drill ed. Do you want to continue? ». If you reply Yes: The entire
drilling plan is ignored, the lens is not drilled and finished in rimless. If you r eply
No, you can remove the lens from the drilling chamber.
Zone inside which drilling is not permitted.
Zone inside which drilling is permitted.
Min. distance from centre of block -> centre of
hole = 19 mm
Max. distance from drill bit centre -> edge of
lens = 12 mm
Zone inside which drilling is not permitted.
Zone inside which drilling is permitted.