Briot emotion, Руководство по эксплуатации

Страница: 82 / 210

Using your Edger... Special cases
3-81
3.5.5.4 P
LACING A FINISHING MANUALLY
3.5.5.4.1 P
RINCIPLE
>
You wish to visualise the lens thickness and adjust the finishing position.
3.5.5.4.2 G
ENERAL PROCEDURE
After opening the job and entering the characteristics, proceed as follows:
Flow chart 3-10: Placing a finishing manually
I
MPORTANT NOTES
>
The finishing position can be modified in 3 ways: Right/left offset, width and depth modification for grooves,
height modification for bevels. Only the apex of the bevel or the middle of the groove is displaced along this
point. The opposite side remains fixed and the curve of the finishing is unchanged.
>
If you wish to reposition the whole finishing, move it in one direction to the required position. Then do the
same from the opposite point.
3.5.5.4.3 S
PECIAL CASES
After the lens feeling, you may have been redirected automatically to the manual finishing screen for the following
reasons:
•
The bevel or the groove are outside the lens.
•
The bevel is too far back.
•
Irregular points were detected during feeling.

You may then reposition the finishing as shown in the flow chart above.
Select the finishing point whose position you wish to modify.
Zone : Press the axis of your choice: top, bottom, temporal, nasal.
A
Move the finishing and position it as you wish.
[If necessary]
At the end of the second lens feeling cycle,
the manual finishing screen is displayed.
[To the rear]
[To the front]
OR
OR
Check that finishing = or .
The axis turns from red to green.