==================================================================================================
x2
2
42
42
22
2
2
42
21
29
22
ASSEMBLY
x2
2
37
Assembly Step 5-B
Hardware Panel 5
Assembly Step 6
Hardware Panel 6
37
2
21
20
13
1. Slide the grip (
29
) over
the end of the lift handle (
22
).
2. Utilizing the holes at the other end of the lift
handle (
22
), find and align with the remaining two
holes of the support assembly (
21
).
3. From the outside edge, run two 5/16 x 1-3/4” bolts (
42
)
through the handle and support assembly.
4. Secure bolts in place with 5/16” hex lock nuts (
2
).
NOTE: For the next step, use the same side of the hopper as the transport lock (3) - added on Step 4.
English Manual
1. On one side, from an outside
edge, run a 5/16 x 3” Hex Bolt (
37
)
through the support assembly (
21
)
and the tow bar (
20
).
2. Add a Hex Lock Nut (
2
) to the bolt.
NOTE: Make sure you do not fully tighten this
nut. There should be a small gap left between the
two tubes to allow for the support assembly (21)
to properly pivot.
3. Repeat on the other side of the hopper and
then add tube caps (
13
) to the ends of the tow
bars as illustrated.
11
1018947-C
