9
If the vacuum pool cleaner always comes back in the same place
Check the swivel joint placed on the top part of the vacuum pool cleaner. It should revolve freely.
Check the backwater and divert it as necessary by the ball recti
fi
er.
Check if the hose is not bent nor broken. A single bend or a break can disable the coverage of
the cleaning surface. Lay up each component of the hose on the edge (or other level surface). The hose
should remain perfectly straight and smooth.
If you pull the vacuum pool cleaner up from the pool,
do not roll the hose up because of its recovery. It would remain bended or cranked.
Removing the dirt from the safety valve
It occurs that the dirt block the bottom part of the vacuum pool cleaner and stop moving the valve or
reduce the
fl
ow. The valve is placed inside of the vacuum pool cleaner’s body and must permanently
move freely. You will see the valve through the opening of the de
fl
ector while turning the vacuum pool
cleaner upside down, see the picture 11. Seize the valve and move it to and fro or rinse the opening by
the help of the hose to remove all dirt from the inside of the vacuum pool cleaner’s body.
In case you fail to remove the dirt in this way, you will be obliged to undo the valve. Pull off four valves
from the bottom part of the disc
fi
rst, unscrew it and remove from the the vacuum pool cleaner body.
Thanm remove the screw from de
fl
ector, pull it out and
fi
nally take out the safety valve. See picture 12.
While the dirt has being removed, put the valve back into the vacuum pool cleaner body, fasten
the de
fl
ector in its place and secure it. See picture 12.
Look on the vacuum pool cleaner from bellow
Latch
is inside
Bottom
of the disc
Folded padding
Defl ector
Defl ector
Safety valve
The vacuum pool
cleaner body
Picture 11
Picture 12
Disc
(no need to remove it)
EN
