6
Check if the immersion mechanism moves loosely and if the immersed controller is installed.
(See the page 2 – how to install the immersion controller.)
Shorten the de
fl
ector by 1,27 cm (Pull up the top end of the de
fl
ector from the detent clamp
conncected to the nosepiece. Shorten it by 1,27 cm, then put it back into the detaining clamp.)
EN
1. The hose is too light
2. Controller load
of the hose
3. The hose is too heavy
1.
The hose is too light. If the hose goes up towards the surface at an angle bigger than 45º, move
the weight closer to the vacuum pool cleaner or move the
fi
rst two weights together closely.
2.
The correct load of the hose.
3
The hose is too heavy. If the hose is dropping at an angle smaller than 45º, move the weight
in the direction from the vacuum pool cleaner or move the
fi
rst two weights further from each
other.
IMPORTANT:
Backwater may act under the pressure on the hose of the vacuum pool cleaner and thus
in
fl
uence its delivery. It may displace the vacuum pool cleaner from the end of the pool where the return
pipe is placed, or may cause that the vacuum pool cleaner will remain only in one part of the pool. To avoid
this, use the spherical recti
fi
er belonging to your vacuum pool cleaner.
Installation:
At
fi
rst, make sure that
the pump of the pool is turned off.
Replace the original recti
fi
er of the vacuum pool cleaner by the ball recti
fi
er.
Change the security ring and tighten it. Make sure that the opening of the ball recti
fi
er is properly
directed before the complete tightening. See “Locations of the ball recti
fi
er”.
Picture 9
