Quick Setup Guide
Trimmer / Brushcutter Models #866014 and #866018
WARNING
Gasoline and its vapors are extremely flammable
and explosive. Turn off engine and wait at least 2 minutes
before refueling. Let spilled fuel evaporate before starting
engine. Always allow space for fuel expansion.
WARNING
Running engine gives off carbon monoxide, an
odorless, colorless, poison gas.
Breathing carbon monoxide can cause headache, fatigue,
dizziness, vomiting, confusion, seizures, nausea, fainting or
death.
•
Operate equipment ONLY outdoors.
•
Keep exhaust gas from entering a confined area through
windows, doors, ventilation intakes, or other openings.
WARNING
Rapid retraction on starter cord (kickback) will
pull hand and arm toward engine faster than you can let go.
Broken bones, fractures, bruises, or sprains could result.
•
When starting engine, pull the starter cord slowly until
resistance is felt and then pull rapidly to avoid kickback.
•
Blade or trimmer head must be securely attached.
WARNING
Moving parts could crush and cut. Starter and
other rotating parts could entangle hands, hair, clothing, or
accessories resulting in serious injury.
•
NEVER operate unit without protective guards in place.
•
DO NOT wear loose clothing, jewelry or anything that could
be caught in the starter or other rotating parts.
•
Tie up long hair.
•
Keep hands and feet away from rotating parts.
Copyright © 2011.Briggs & Stratton Power Products Group, LLC.
Unpack Trimmer/Brushcutter
1. Remove everything from carton except trimmer/brushcutter.
2. Open carton completely by cutting each corner from top to bottom.
3. Ensure you have all included items prior to assembly. If items are missing, contact your
local authorized dealer.
Assemble Trimmer/Brushcutter
Items Included:
Overview of Trimmer/Brushcutter
Install Trimmer Head to the Cutting Head - Figure 1
1. Align the hole on the cutting head (
A
) to the
notch (
B
) on the spline pad (
C
).
2. Use Allen Wrench (
D
) to hold spline pad in
position.
3. While holding Allen wrench in place,
install the trimmer head (
E
) by turning in a
clockwise direction.
NOTE:
Ensure that the spline pad is placed in
the correct position when installing.
The shoulder side
must
face the cutting
head.
TOOL
SET
Safety Glasses
Tool Set
Operator’s
Manual
Carrying
Harness
Fuel and Oil
Bottle
Nylon
Trimmer head
Brushcutter
Blade
Trimmer Head/Brushcutter Guard
Install Trimmer Head Guard - Figure 2
1. Remove the two screws (
A
) from guard.
2. Position guard and saddle (
B
) at hole in
straight shaft.
3. Install the two screws through the saddle
and into the guard.
4. Remove third screw (
C
) from the tool set
bag, and install into the drive shaft.
NOTE:
The third screw (
C
) is shorter than the
two screws (
A
) installed in guard.
Figure 1
Form No. 80000100_D
Figure 2
A
B
C
A
B
C
D
E
Not
for
Reproduction