IS5100Z Series - 33 HP Diesel
61” iCD Mower Deck
5
Roll Bar Assembly
Assemble Retainer Pins
1. Unpack the roll bar and hardware from the box.
2. Assemble the foam ring (A, Figure 6) onto the
retainer pin (B).
3. Loop the snap end of the lanyard (C) through the
retainer pin handle and snap together.
4. Install the lanyard anchor (D) onto the lanyard.
5. Install the clevis pin (E) onto the loop end of the
lanyard as shown in Figure 6.
Assemble the Top Loop
1. Install the plastic cap (B, Figure 7) into the end of the
top loop tube (A). Repeat for other end of tube.
2. Make sure the rubber stop (C) is properly seated
against the inside of the pivot mount. See Figure 7.
Figure 6. Assemble the Retainer Pins
A. Foam Ring
B. Retainer Pin
C. Lanyard
D. Lanyard Anchor
E. Clevis Pin
A
B
C
D
E
Figure 7. Assemble the Top Loop
A. Top Loop Tube
B. Plastic Cap
C. Rubber Stop
A
B
C
Install the Roll Bar
1. Make sure the roll bar sockets are clear of any
obstructions, wires, foreign objects, etc.
2. Install the roll bar upright tubes (A) into the sockets
as shown in Figure 8. Loosely install the 1/2-13 x 4”
bolts and hex side lock nuts (B, Figure 8).
NOTE: See Figure 9 for proper upright tube orientation.
Figure 8. Installing Roll Bar
A. Upright Tubes (LH Side Shown)
B. 1/2-13 x 4” Bolts & 1/2-13 Hex Side Lock Nuts
A
B
Snap End
Loop End
Not
for
Reproduction