Briggs & Stratton 71 Piece Air Tool Kit, Руководство оператора

Страница: 6 / 44

4 BRIGGSandSTRATTON.COM
A Asssse em mb bllyy
The air tools need some assembly and
lubrication before first use. Use the instructions
below to attach air fittings (coupling plugs) and
lubricate the air motors.
Attach Air Fittings
This kit is supplied with “type I/T” air hose
connector fittings. Attach a coupling plug (male
fitting) to the tool, as follows:
1. Remove shipping cap from air inlet of air
tool and discard cap.
2. Wrap male threads of plug with two turns of
supplied thread seal (teflon) tape, applied
counterclockwise.
3. Thread plug into air tool’s air inlet until snug.
4. Using supplied wrenches, tighten plug
another 1/2 to 1 full turn.
Repeat steps 1-4 above for the other air tools in
the kit.
Confirm that the air tool plug fits the quick-
connect coupling (female fitting) at the end of
your air hose. If you are unable to make the
connection, change the air hose coupling as
follows:
1. Using adjustable wrenches or the supplied
wrenches, detach the quick connect
coupling from the air hose.
2. Carefully remove all traces of sealing tape
or joint compound from threads on air hose
fitting.
3. Wrap male threads of air hose fitting with
two turns of supplied thread seal tape,
applied counterclockwise.
4. Thread supplied quick-connect fitting onto
air hose, being careful to not cross thread
the connection. Finger tighten until snug
5. Using supplied wrenches, tighten plug
another 1/2 to 1 full turn.
Your air tools are ready for initial air motor
lubrication.