Not for
Reproduction
19
19
Operation
Starting the Engine
1. While sitting in the operator’s seat, engage the parking
brake by pulling the parking brake lever up, make sure
that the PTO switch is disengaged (pressed fully down)
and the ground speed control levers are locked in the
NEUTRAL position.
2. NOTE: A warm engine may not require choking.
Set the engine throttle control to FULL throttle position.
Then fully close the choke by pulling the knob OUT fully.
3. Insert the key into the ignition switch and turn it to the
START position.
4. After the engine starts, gradually open the choke (push
knob down fully). Reduce to half throttle speed and
allow the engine to warm up.
Warm up the engine by running it for at least a minute
before engaging the PTO switch or driving the unit.
5.
After warming the engine, ALWAYS operate the unit at
FULL THROTTLE when mowing.
In the event of an emergency the engine can be stopped by
simply turning the ignition switch to OFF.
Use this method
only in emergency situations. For normal engine shut down
follow the procedure given in
Stopping the Mower
.
Stopping the Rider and Engine
1. Returning the ground speed control levers to the middle
position will stop rider movement. Pivot the levers
outward and lock them in NEUTRAL.
2. Disengage the PTO by pushing down on the PTO switch.
3. Engage the parking brake by pulling the handle up until it
locks into position.
4. Move the throttle control to mid-throttle position and
turn the ignition key to OFF. Remove the key.
Safety Interlock and Mower Deck Positioning
Instructions
This unit is equipped with an safety interlock system to
help keep the operator safe while running the unit. Please
read and understand the SAFETY INTERLOCK SYSTEM and
FEATURES AND CONTROLS sections before attempting to
drive or operate the mower. In order for the unit to operate
properly, the controls must be in the correct positions and
used in the correct sequence.
Driving the Mower:
The mower deck MUST either be positioned in the Operating
position or the Service position BEFORE you move the
ground speed control levers out of the NEUTRAL position.
If not, the safety interlock system will cause the engine to
shut off. The safety interlock system will prevent you from
driving the mower UNTIL the mower deck is positioned in
either the Operating or Service position.
Operating the Mower:
The mower deck MUST be positioned in the Operating
position BEFORE engaging the PTO clutch. If not, the PTO
will NOT engage and remain off UNTIL the mower deck is
properly positioned in the operating position, the PTO switch
is DISENGAGED and then RE-ENGAGED.
If you raise the mower deck from the operating position with
the PTO clutch ENGAGED the PTO will shut off and remain
off UNTIL the mower deck is properly positioned in the
operating position, the PTO switch is DISENGAGED and then
RE-ENGAGED.
WARNING
Read the Operator’s Manual before
attempting to operate the machine.
• If you do not understand how a specific control
functions, or have not yet thoroughly read the FEATURES
and CONTROLS section, do so now.
• Do NOT attempt to operate the tractor without first
becoming familiar with the location and function of ALL
controls.
