Briggs & Stratton 040298, Руководство по обслуживанию и устранению неисправностей

Страница: 35 / 68

31
2
2
TEST 3 - Check Engine Oil Pressure
1. Remove the oil pressure switch and install a
technician supplied oil pressure gauge.
2. Set control panel system switch to AUTO , then push
and hold the MANUAL OVER-RIDE to start the unit.
3. Pressure reading on gauge should be 10-50 PSI
(0.7-3.5 Bar).
• If oil pressure is normal and oil switch did not
open in Test 2, replace the oil switch and repeat
Test 2.
• If oil pressure is low, see Single Cylinder OHV
Repair Manual (#276781) to troubleshoot the
source of problem.
Not
for
Reproduction