Bridgeworks WANrockIT 200, Руководство пользователя

Страница: 11 / 83

Quick Start Guide
The following are basic steps required to setting up your WANrockIT 200. These instructions are
meant for those that have previously read this manual, and are setting up an additional Node. If
this is your first time setting up a Node, please read all the sections in this manual to ensure that all
the parameters of the WANrockIT 200 are set up properly.
1. Connect the “MGMT” and “WAN” ports found behind the WANrockIT 200 to your network.
See Section 3.1: Connecting the Ethernet Interface .
2. Connect the Fibre Channel ports found behind the WANrockIT 200 to your Fibre Channel
device and host. By default, Port A (left port) is the Target port, and Port B (right port) is the
Initiator port. See Section 3.2:
Connecting the Fibre Channel Interface .
3. Power on the WANrockIT 200. See Section 3.3: Connecting the Power Supply .
4. If your WANrockIT 200 is in a remote location, use a local Node to Remotely Control it. Add
the remote Node in Node Management and Start Remote Control . See Section 6.1.2: Adding
Nodes .
5. Login to the web interface and set your new password. See Chapter 4: Using the Web
Interface .
6. Add a remote node in the Node Management page. See Chapter 6: WANrockIT Configuration .
7. Perform a Learn between your WANrockIT 200 and the remote node. If the speed between
your nodes is less than what you expect, ensure that the network the WAN port is connected
to is not already congested. See Section 6.1.6:
Learning .
8. Enable devices connected to the remote node using the Remote SCSI Target Management
page. See Section 6.2: Remote SCSI Target Management .
11