Installing the EFC102200 Gateway
The following are the basic steps to installing the EFC102200:
• Connecting the Ethernet cables
• Connecting the 10Gb Ethernet cables
• Connecting the Fibre Channel Interface
• Connecting the Power Supply
Connecting the Ethernet Interface
The EFC102200 Management Interface can be used on the following network configurations:
• 10BASE-T
• 100BASE-T
• 1000BASE-T (Gigabit)
It is not necessary to specify which network type you are connected to, as the EFC102200 will
automatically select the correct network speed.
The connection to the management Ethernet network can be found at the back of the EFC102200,
labelled “MGMT A” and “MGMT B”.
To connect the EFC102200 to the management Ethernet network, insert a Cat 5E cable (or better)
into one of the “MGMT” ports at the back of the unit as shown in the following image. When the plug
is in the correct position a “click” should be heard. The other end of the cable should be connected
to a network.
12
