Note: Only use SFP transceivers that meet or exceed the following standards:
EU: IEC/EN 60825-1, North America: FCC, CDRH
Note: SFPs will come pre-installed when a Fibre Channel card has been
purchased with your configuration.
The following multi-mode optical fibre cables are supported up to the lengths given:
Fibre Channel Speed
OM1
OM2
OM3
OM4
2Gb/s
150m
300m
500m
4Gb/s
70m
150m
380m
400m
8Gb/s
21m
50m
150m
190m
16Gb/s
15m
35m
100m
125m
32Gb/s
20m
70m
100m
Connect your host to a target port and your device (such as a tape drive) to an initiator port.
Note: By default WANrockIT units have the left hand port (Port A) as the
target port and the right hand port (Port B) as the initiator port.
When the multi-mode cables are inserted in to the SFP, a “click” should be heard.
2.6
Connecting the Power Supply
Important: Before connecting the power cord, ensure that the wall or rack
plug is removed or is switched off.
With a redundant power supply configuration, the system evenly distributes power across both
power supplies to maximise efficiency. In order to utilise this feature, please ensure that both power
supplies are connected.
Connect the power supply to the rear of the Appliance as shown below and turn on the power from
10
