Note: SFPs will come pre-installed when a 10GBASE-SR feature card has
been purchased with your configuration.
Insert the multi-mode cables in to the SFP as shown below. When the plug is in the correct position
a “click” should be heard.
Using a Copper Interface Cable (SFP+)
If you are using a copper based solution, an SFP+ Direct Attach Copper (DAC) Twin-Ax interface
cable must be used; the maximum supported length of which is a 7 meter passive cable.
To connect the Appliance directly to a device, insert one or two SFP+ cables in to the connector as
shown below. When the plug is connected a “click” should be heard.
10