11 / 24
6. Repeat steps 1 to 4 as before.
7. Place the assembly base with its bottom site first on the tube. Push the tube bracket against the
tube from the opposite site.
8. Slide 4 screws through the bore holes of the assemby base and through the bore holes of the tube
bracket on the other site.
9. Put on the 4 nuts and tighten the screw connection by hand.
13 Signal transmission
The base station will automatically connect to the outdoor sensor. Press the SENSOR button to start a
manual search for the sensor. When the connection is successful, the sensor signal strength indicator
will be shown on the display.
Connection status display
Connection status
Screen display
Good signal
Reception symbol
Searching for a sensor
Reception symbol flashes
No signal for 48 hours
'Er' (Error) is shown
Sensor low battery status, good signal
Battery symbol is shown
14 Automatic time setting
After the power supply was established, the clock will automatically search for the radio signal. It takes
about 3-8 minutes to complete this process.
If the radio signal is received correctly, the date and time will be set automatically and the radio control
signal icon turns on.
If the clock fails to receive the time signal, go ahead with the following steps:
1. Press RCC button on the base station until radio signal symbol flashes.
2. If the device is still not receiving the signal, the time must be set manually.
Read the detailed manual for more information about manual time and alarm setting (see download in-
formation on page 2).
15 Manual time setting
To set the time / date manually, first disable the reception of the time signal by pressing the RCC but-
ton for approx. 8 seconds.
1. Press TIME button for approx. 3 seconds to enter time setting mode.
2. Digits to be set are flashing.
3. Press UP or DOWN button to change the value.
4. Press TIME button to confirm the entry and move to the next setting.
5. Settings order: 12/24 hour mode > Hours > Minutes > Seconds > Year > Month > Day > Time off-
set > Language > Daylight saving time Auto/off
6. Finally press the TIME button to save the settings and exit the setting mode.
16 Time zone setting
To set a different time zone, proceed as follows:
1. Press TIME button for approx. 3 seconds to enter time setting mode.
2. Press the TIME button several times until the display shows 00 Hr time offset.
3. Press UP or DOWN button to select the desired time deviation in hours (-23 up to +23 hours).
4. Press TIME button forapprox. 3 seconds to confirm the selected time deviation.
Содержание Weather Center XXL JC + sensor 5in1
