Bresser MyTime Easy, Инструкция по эксплуатации

Страница: 27 / 32

27
USING THE ALARM AND SNOOZE FOR
DAILY ALARM 1 or ALARM 2
• Press the / (ON/OFF) button to
turn the alarm1 on, or the alarm1 off / the
alarm 2 on, or the alarm2 off.
• When the current time reaches the alarm
time that is enabled, the corresponding
alarm is activated.
• When the alarm1 / alarm 2 is ringing, the
relative alarm icon [ ] / [ ] will be
flashing.
• Press the relative alarm button [ ] / [ ]
to turn the alarm off.
• Press SNOOZE.LIGHT button - alarm
stops and the backlight will turn on for 5
seconds with deleted, the repeat alarm
indicator ( ) flashing. The alarm sounds
again after 4 minutes.
• If the alarm is not turned off, it will stop
automatically after 2 minutes.
RECEIVING THE DCF RADIO CONTROL
SIGNAL
The radio-controlled clock will automatically
receive the radio signal at 1:00 o‘clock in
the morning every day. It will take 3-5 min-
utes to receive the radio signal. If the re-
ception is not successful received at 1:00
o‘clock, it shall be held further attempts at
2:00 o‘clock and 3:00 o‘clock. If the DCF
signal is received, the DCF tower will be visi-
ble on the display, otherwise it will not.
BACKLIGHT
• Press top button SNOOZE.LIGHT - back-
light will come on and turn off automatical-
ly after 5 seconds.
• The device is provided with a light sensor
to turn on the light automatically at dark.
appears on the display. Press and
hold the SNOOZE.LIGHT button to deac-
tivate the backlight.
Disappears on the
display.
Note: During a DCF signal reception, the
lighting cannot be activated.
LOW BATTERY LEVEL DETECTION
Should the battery capacity drop to a level
that is not sufficient to operate the clock, the
low battery indicator will light up. The battery
should be replaced as soon as possible.
Attention!
Please dispose of used batteries in an eco-
logically safe manner.