9 / 32
13 CHANNEL button (setting mode for the re-
mote control)
14 ON/OFF button (switch device on/off)
15 Adjusting knob (increasing or decreasing
setting value)
16 DMX connection socket (RJ11)
17 DMX button (setting mode for DMX con-
trol)
18 DIMMER button (setting mode for the light
intensity)
19 3-pins socket (connection top the power
unit)
20 Battery socket (adding suitable batteries*
for mobile use) (optional)
21 C13 mains socket
22 3-pins socket (connection to the control/
battery unit)
23 4/5-pins data cable (connection betweeen
power unit and control/battery unit)
24 C13 power cable with Euro-plug
25 3/3-pins connection cable (connection
between power unit and control/battery
unit)
*2x V-lock battery not included
6 Connecting power unit and battery/control unit
1. Put the C13 coupling of the power cable into the C13 socket at the power unit.
2. Put 3-pins plug of the connection cable into the 3-pins socket at the control/batterie unit.
Find more information on how to etablishing the power supply in the following chapters.
7 Establishing the power supply (mains operation)
WARNING! The device can not be operated at the same time by mains power adapter and by
battery! To avoid voltage damage, always operate with only one of the two possible voltage
sources!
1. Put the C13 coupling of the power cable into the C13 socket..
2. Put 5-pins plug of the data cable into the 5-pins socket at the control/power box.
3. Put the 4-pins plug of the data cable into the 4-pins socket at the LED light.
4. Put the Euro-plug of the power cable into the wall socket (230V maximum voltage).
CAUTION! When switching on the device, make sure that the ON/OFF toggle switch is moved to
the correct position for the desired voltage source (mains adapter or battery)!
5. Move voltage toggle switch to position 'ADAPTER' to operate the device by mains power and to
turn on the device.
6. Press ON/OFF button for approx. 2 seconds to turn on the light.
7. Press ON/OFF button again for approx. 2 seconds to turn off the light.
NOTICE! If the device is not used for a long time, disconnect the device from the power supply
(pull out mains plug or remove battery).
8 Power supply via battery (optional)
WARNING! The device can not be operated at the same time by mains power adapter and by
battery! To avoid voltage damage, always operate with only one of the two possible voltage
sources!
As an alternative to the power supply through mains voltage, the device can also be powered by a bat-
tery*.
NOTICE! Only use the type of battery described in this manual. Use of an unsuitable or unau-
thorized battery will damage the device and void the warranty.
