10 / 24
12 Receiving measurements automatically
Once the power supply is enabled, the base station will display the measurement readings for indoors.
First readings from the outdoor sensor will be displayed within 3 minutes after powering it on.
If no signal is received, proceed as follows:
Press the UP button for about 2 seconds to initate reception of measurements again.
13 Manual measurement display
1. Press MAX/MIN button several times to display the stored values one after another.
2. Display order: Current values > MAX (highest values) > MIN (lowest values)
3. When displaying highest or lowest values, press and hold MAX/MIN button for approx. 3 seconds
to delete all saved values.
14 HI/LO Alert
HI/LO alert are used to alert you of certain weather conditions. Once activated, an alarm sound is
triggered and the alert icon flashes as soon as a set value is reached. Supported areas and alarm
types:
Area
Type of alert available
Indoor temperature
HI AL / LO AL
Indoor humidity
HI AL / LO AL
Outdoor temperature
HI AL / LO AL
Outdoor humidity
HI AL / LO AL
HI AL = High alert / LO AL = Low alert
HI/LO alert setting
1. First, select an area (channel 1, 2, 3 or Indoor). Press the UP button repeatedly until the arrow in-
dicator is at the desired position.
2. Press and hold ALARM button for approx. 3 seconds to enter the setting mode.
3. Press UP or DOWN button to change the value.
4. Press ALARM button to confirm and continue to the next setting.
5. Settings order: Temperature HI AL > Temperature LO AL > Humidity HI AL > Humidity LO AL
Enable/Disable HI/LO Alert
6. First, select an area (channel 1, 2, 3 or Indoor). Press the UP button repeatedly until the arrow in-
dicator is at the desired position.
7. Press and hold ALARM button for approx. 3 seconds to enter the setting mode.
8. Press and hold ALARM button again for approx. 3 seconds to activate the temperature alarm.
9. Press ALARM button to confirm and continue to the next setting.
Note:
10. When ALERT alarm is on, the area and type of alarm that triggered the alarm will be flashing and
the alarm will sound for 2 minutes.
11. Press SNOOZE/LIGHT button when alarm sounds to interrupt the alarm. The alarm will then start
again after 2 minutes.
