BREDA LUDWT30155, Руководство по эксплуатации

Страница: 23 / 37

Troubleshooting
Action Type of fault on the display
Clear the drain pump. See the chapter Care and maintenance in-
structions. If the problem persists, call the Customer Care Center. Overfilling F10
See “Water remains in the dishwasher above the filters” in the table
“Problem” below. If the problem persists, call the Customer Care
Center. Water outlet fault F11
Check that the water supply valve is on. If the problem persists,
call the Customer Care Center. Water inlet fault F12
Turn off the water supply valve and call the Customer Care Center. Inlet valve leakage F40
Clean the coarse and fine filters. If the problem persists, call the
Customer Care Center. Water level fault F52
Turn off the water supply valve and call the Customer Care Center. Overfilling F54
To avoid water leakage outside the dishwasher, do not remove
the plug from the power outlet until the supply pipe has been
turned off!
Call the Customer Care Center. Circulation fault F56
Check that the water supply valve is on. If the problem persists,
call the Customer Care Center. Water inlet fault F67
Press any button to clear the error message.
Action Possible causes Problem
Wait a moment then try again. You have pressed the buttons
too soon after opening the door. The buttons do not react when
pressed.
Clean with a dry or slightly
damp cloth. The buttons are dirty.
Open the door. The buttons only
react to use when the door is
open. The door is closed.
Check that the baskets are cor-
rectly positioned horizontally. The baskets are not correctly
positioned. Cannot close door.
Check that the dishes are not
blocking the baskets from slid-
ing properly into place.
Check the door lock. If it does
not click into place and lock,
open the door. The door lock does not click in-
to place and lock.
Press and hold the button for
the Auto open option until the
button starts flashing. Wait until
it stops flashing (60 seconds).
Close the door. Check that the
door lock clicks into place and
locks.
23