14
© 2020 Breckwell Hearth
NOTE: When the stove is set on “1” the “reset trim” values
will be shown on the Heat Level Advance bar graph. For
example if the Reset Trim is set to its lowest setting every
time the stove is set to low the “1” and “4” lights will be
illuminated on the bar graph.
e. HEAT LEVEL ADVANCE
• This button when pushed will set the pellet feed rate, hence
the heat output of your stove. The levels of heat output will
incrementally change on the bar graph starting from level
“1” to “5”.
NOTE: When dropping 3 or more heat level settings (4 to
1, or 5 to 2 or 1) push the ‘High Fan’ button and allow the
room air fan to run at that setting for at least 5 minutes to
prevent the stove from tripping the high temp thermodisc. If
the high temp thermodisc does trip see “SAFETY FEATURES”
section of this manual.
CAUTION:
THE “5” SETTING IS DESIGNED FOR TEMPORARY
USE ONLY. IF USED FOR EXTENDED PERIODS, IT CAN
SIGNIFICANTLY REDUCE THE LIFE EXPECTANCY OF THE
ELECTRICAL COMPONENTS. AVOID USE AT THIS SETTING
FOR MORE THAN ONE OR TWO HOURS AT A TIME.
OPTIONAL THERMOSTAT
CONNECT
THERMOSTAT
WIRES HERE
A thermostat may help you maintain a constant house
temperature automatically. A millivolt thermostat is required.
The control panel can be set up two ways to operate your
stove in thermostat mode.
THERMOSTAT INSTALLATION
• A millivolt thermostat is required.
• Unplug stove from power outlet.
• Remove control board from stove.
• The two thermostat wires connect to the terminal block on
the lower left side of the back of the control board.
• Insert the wires in the terminal side and tighten the two
screws.
MODES
To switch between any of the three modes the stove must
be shut off, the new mode selected, and the stove restarted.
MANUAL MODE
• Use this mode exclusively if you do not connect an
optional thermostat
• In this mode the stove will operate only from the control
panel as detailed in the “operation” section of this owner’s
manual.
HIGH/LOW THERMOSTAT MODE
• Use this mode only if you connect a thermostat
• When engaged in this mode the stove will automatically
switch between two settings. When warm enough, it will
switch to the #1 or low setting. The room air blower will
also slow to its lowest speed.
• The heat level advance setting on the bar graph will stay
where it was initially set. When the house cools below the
thermostat setting, the stove will switch to the feed rate of
the heat level advance setting.
ON/OFF THERMOSTAT MODE
• Use this mode only if you connect a thermostat
• In this mode when the home is warm enough the stove will
shut off. The fans will continue to run until the stove cools.
• When the home cools below the thermostat setting, the
stove will automatically restart and run at the last feed
rate setting. NOTE: When in “high/low” or “on/off”
thermostat mode – Do not operate the stove higher than
the #3 setting. Set damper control rod approximately
1/4” to 1/2” out. This will vary depending on elevation
and weather conditions. Observe stoves operation and
adjust damper as necessary.
OPERATION
Содержание SP24i
Страница 31: ...2020 Breckwell Hearth 31 NOTES...
