Breas Medical Vivo 45, Руководство пользователя

Страница: 19 / 226

19 Safety Information
Vivo 45 User Manual
Doc.006149 En Y-2
2.5 Usage of Filters
• Always use the Vivo 45 with patient air inlet filters installed. Only use
the Vivo 45 with accessories recommended by Breas Medical AB.
• Replace or clean the filters regularly to ensure correct function of the
Vivo 45, especially when changing patient. Failure to replace or clean
a dirty filter may cause the Vivo 45 to operate at higher temperatures
than intended. A dirty filter may be caused by dust or animal hair in
the home environment.
• When operating the Vivo 45, make sure that the air inlet and filters
are not obstructed or occluded.
• The use of a high resistance bacterial filter on the output of the
device may interfere with the operation of the patient disconnect
function. It may also interfere with the device trigger function. The
impact can be reduced by conducting a pre-use test properly (see
“Performing the Pre-use Test” on page 41).
• When adding, changing or removing any kind of filter, always reas-
sess the settings, including alarm settings and perform a pre-use test.
• If the Vivo 45 is used in a setting where it will be used by multiple
patients, a low resistance bacterial filter is recommended between the
air outlet and the patient circuit to prevent patient cross-contamina-
tion (Breas Medical AB recommends the low resistance bacterial fil-
ter part no. 004185).
• Reuse of mask, patient circuit or bacterial filter may expose patients
to contagious agents.