BRAYER BR4261, Инструкция по эксплуатации

Страница: 10 / 48

10 EN
• It is recommended to clean the dust bin after every
use of the vacuum cleaner. Regularly clean the
separator (18) and the HEPA-filter (15).
• Remove the extension pipe (3), to do it, press and hold
the clamp (4) (pic. 2).
• Remove the dust bin from the motor unit of the
vacuum cleaner by pressing the clamp (6) (pic. 1).
• To remove dust and garbage place the dust bin above
the garbage bin, press the clamp (14) and open the lid
(13), remove the garbage and dust and close the lid
(13) until the clamp (14) clicking.
Cleaning the dust bin
• Before disassembling the dust bin remove dust and
garbage from it as described above.
• Take the upper lid (5) of the dust bin, turn it
counterclockwise and remove from the flask (12) (pic.
4).
• Remove the separator (16) from the flask (12) (pic. 4).
• Turn the HEPA filter (15) counterclockwise « » and
remove it from the separator (16) (pic. 5).
• Wash the separator (16) and the HEPA filter (15)
under a warm water jet and dry them (pic. 6, 7). Do
not dry the HEPA filter (15) with a hairdryer or similar
appliances.
• Wash the filters under a warm water jet and dry them.
Do not dry the HEPA-filter (15) with a hairdryer or
similar appliances.
• Wash the dust bin flask (12) and dry it.
• Do not wash all removable parts in a dishwashing
machine.
Note: before assembling the dust bin make sure that all
removable parts are clean and dry.
Assembling of the dust bin
• Insert the HEPA filter (15) in the separator (16) and turn
it clockwise « » (pic. 5).
• Install the separator (16) in the dust bin flask (12).
• Install the upper lid (5) on the flask (12) and turn it
clockwise.
• Install the assembled dust bin in the installation place
until the clamp (6) clicking and make sure that the dust
bin is fixed properly.
Cleaning the electric brush
• When using the electric brush (1) threads or long hair
etc. can wind up around the rotating brush (21). Keep
the electric brush (1) clean, disassemble the brush (1)
and clean the round brush (21) as it becomes dirty.
• Remove the electric brush (1) from the extension pipe
(3) by pressing the release button (2).
• Turn over the brush (1), turn the clamp (20)
counterclockwise with a flat screwdriver and remove it.
Remove the round brush (21) and remove the threads
and hair wound up around the brush.
• Clean the inner and outer surface of the electric brush
(1) body from garbage and dust.
Assembling the electric brush
• Insert the left part of the round brush (21) into the body.